Skip to main content

Clean Power Rule to change fuel mix

Published by
Hydrocarbon Engineering,


The Environmental Protection Agency's proposed Clean Power Plan rule would result in major changes in the fuel mix used to generate electricity in the United States. This is according to recently analysis from EIA.

From the analysis, the main compliance strategy to lower emissions rates is to increase natural gas-fired generation to displace and ultimately surpass coal-fired generation. Subsequently, as more wind and solar capacity are added, renewable generation also surpasses coal-fired generation.

Renewables and energy efficiency programs benefit from a compliance formula that counts renewable generation or, in the case of efficiency, avoided generation in the denominator of the compliance formula for existing fossil generation.

Changes in the fuel mix play out in different ways across the country, reflecting regional variation in the economics of increases in natural gas generation and renewable capacity. Key determinants include baseline combined-cycle utilisation rates and the potential for renewable generation in areas without renewable portfolio standards.

Future energy market conditions unrelated to the proposed Clean Power Plan rule can significantly affect the electricity generation mix and other key energy market outcomes. For this reason, EIA's analysis also modelled the proposed rule using the High Oil and Gas Resource (HOGR) and High Economic Growth cases from AEO2015 as alternative baselines. The HOGR case reflects a scenario in which more abundant domestic natural gas resources and better technology enhance natural gas supplies, keeping projected annual average spot natural gas prices below US$4.50 per million Btu through 2040.

Even before the proposed rule is considered, natural gas plays a much larger role in the generation mix, largely at coal's expense, in the HOGR case than in the Reference case. In the Reference case, coal generation at existing coal plants is supported by a steady rise in natural gas prices beyond 2020, with annual average spot prices exceeding $7.50 per million Btu by 2040. When the proposed rule is modelled using the HOGR case as the baseline, natural gas plays a larger role in compliance, with the natural gas-fired share of total generation rising to 37% in 2020 and 44% in 2030. Renewables grow at a slightly lower rate, while the share of coal-fired generation declines to 28% in 2020 and 19% in 2030.

In addition to the Base Policy case, EIA's analysis includes several sensitivity cases encompassing different interpretations or implementations of the proposed rule as well as a scenario in which further emissions reductions are required beyond 2030, all of which use the AEO2015 Reference case as their baseline.

The Policy Extension case requires a further reduction in emissions rates between 2030 and 2040 rather than simply maintaining the 2030 standards through 2040. The impacts on fuels used to generate electricity are similar to those of the Base Policy case through 2030. However, generation from renewable energy sources continues to grow post-2030, ultimately accounting for 32% of generation by 2040, compared to 27% in the Base Policy case and 18% in the Reference case.

EIA also considered a case in which new nuclear units not already under construction were treated for compliance purposes similar to other non-carbon generation. Under this case, nuclear capacity reaches 121 gigawatts by 2040, compared to 105 gigawatts of nuclear capacity in the Reference case and 102 gigawatts in the Base Policy case. The additional increase in nuclear generation replaces some of the growth in renewable generation.

The Clean Power Plan also has implications for electric generation capacity, both in terms of additions and retirements. These capacity changes will be the subject of a subsequent Today in Energy article.


Adapted from press release by Joseph Green

Read the article online at: https://www.hydrocarbonengineering.com/refining/28052015/clean-power-rule-change-fuel-mix-855/


 

Embed article link: (copy the HTML code below):