Skip to main content

Control Instruments Corporation on minimum ventilation rates

Published by , Editorial Assistant
Hydrocarbon Engineering,


There are several fundamental safety precautions, which should be applied to all dryer designs. These requirements call for a minimum, below which the ventilation rate is never reduced. This predetermined, fixed value is calculated from solvent input and flammability characteristics.

Fundamental safety does not require use of an analyser, however, if none are used then the lower flammability limit (LFL) is usually decreased to about one half of the value allowed when an analyser is installed.

Without an analyser present, there is little corrective action in case of a fault. Safety depends on:

  • The accuracy of the calculations for flammability of the solvent mixture(s) to be used.
  • The maintenance of the minimum ventilation rate.
  • The limitation of the solvent load by mechanical means.

If the solvent load increases to a high level, the hazard of fire or explosion is limited solely by the magnitude of solvent increase and presence, or absence, of an ignition source. If the increase exceeds the margin of safety as designed, a fire or explosion can occur. Failures can include:

  • Excessive coating weight.
  • An increase in line speed.
  • A reduction in ventilation.
  • A change in solvent mixture.
  • An increase in web width.

The minimum ventilation calculations should be made for the ‘worst case’ scenario. This includes the maximum weight, or liquid volume, of solvent to be applied, the fastest speed of the process, the maximum web width, the maximum flammability of the solvent types to be used, and also a consideration of likely failure modes such as the loss of tension, loss of solvent metering, or loss of ventilation. Without an analyser, the highest margin of safety should be used, which usually means the solvent concentration limit is 20% or 25% LFL.


Adapted from press release by Francesca Brindle

Read the article online at: https://www.hydrocarbonengineering.com/gas-processing/11032016/cic-release-advice-on-minimum-ventilation-rates-2749/

You might also like

TotalEnergies and SINOPEC join forces to produce SAF

TotalEnergies and China Petroleum and Chemical Corp. (SINOPEC) have signed a Heads of Agreement (HoA) to jointly develop a sustainable aviation fuel (SAF) production unit at a SINOPEC's refinery in China.

 
 

Embed article link: (copy the HTML code below):